NSK 2308-C3 Self-Aligning Ball Bearing - 40 mm ID, 90 mm OD, 33 mm Width Automotive Cutting controlled by manual pressure

Cutting controlled by manual pressure

Due to the supplied ‘heavy weight’ hammer it only requires a few hits to tap the bearing or seal into place

The 3-jaw design guarantees an even load distribution and thus a particularly secure grip on the part being pulled

the PWT-04 pairs with PT series locknuts to secure

The bell-shaped hydraulic ball joint puller of series 128-H is used to press out the ball pins when removing ball joints and tie rod ends on tie rods

NSK 2308-C3 Self-Aligning Ball Bearing - 40 mm ID, 90 mm OD, 33 mm Width Automotive Cutting controlled by manual pressureSelf Aligning Ball Bearing NSK self aligning ball bearings have two rows of balls and a common spherical outer raceway. They tolerate shaft and housing misalignment and accommodate moderate radial loads with low friction. They are ideal for applications where shaft deflection or mounting errors are expected.